2000字范文,分享全网优秀范文,学习好帮手!
2000字范文 > 晶体尺寸 Crystal size英语短句 例句大全

晶体尺寸 Crystal size英语短句 例句大全

时间:2019-03-10 05:48:50

相关推荐

晶体尺寸 Crystal size英语短句 例句大全

晶体尺寸,Crystal size

1)Crystal size晶体尺寸

英文短句/例句

1.Measurements on the Size of CsI(TI) Crystals of Electromagnetic Calorimeters in BESIII北京谱仪III电磁量能器晶体尺寸的测量

2.Research on Growth of Large CsB_3O_5 Crystal and Its Applications;大尺寸CsB_3O_5晶体生长及应用研究

3.Austenite grain size and continuous cooling transformation behavior in 20CrMoNb gear steel齿轮钢20CrMoNb奥氏体晶粒尺寸及相变行为

4.Analysis of the size effect of crack generation in the large-scale KDP crystals during its growth大尺寸KDP晶体生长开裂的尺度效应分析

5.Dependences of Size and Pressure on the Melting Temperature of Nanocrystals;纳米晶体熔化温度的尺寸和压力依赖性

6.Growth and Physical Peoperties of Large Size and High Quality Nd:YAG Layer Crystal;优质大尺寸Nd:YAG激光晶体的生长与物性研究

7.Growth Defect and Annealing Modification Analysis of Large-Sized SiC Crystal大尺寸SiC晶体的生长缺陷及退火改性研究

8.Relationship Between Grain Size and Aging Behavior of Co-Free Maraging SteelT250马氏体时效钢晶粒尺寸对时效析出的影响

9.Crack during the Growth of Large Scale Sapphire by SAPMAC Method ProcessSAPMAC法生长大尺寸蓝宝石晶体的碎裂分析

10.Calibration of NaI(Tl) Detectors" Detection Efficiency in Different Dimension Using Monte Carlo MethodMonte Carlo方法对不同尺寸NaI(Tl)晶体探测效率的刻度

11.The evolution equations of the volume fraction of dynamic recreastallization and varieties of grain size are derived from this model.由此模型导出了再结晶体积分数及有关晶粒尺寸的演化方程。

12.Influence of Hydrogen Flow on Grain Size of Nano-Crystalline Sic Films Grown by HFCVD MethodHFCVD法制备纳米晶体碳化硅薄膜中氢流量对晶粒尺寸的影响

13.The transformed ferrite volume fraction increases and grain size decreases with the increase of cooling rate.随着冷却速率的增加,铁素体体积分数减少,晶粒尺寸变细。

14."Transistors were pivotal in the advancement of electronics because of their small size, low power requirements, low heat generation, modest cost, reliability, and speed of operation."晶体管在电子学的发展中起了关键性作用,它的尺寸

15.Investigation of Simulation Analysis and Its Application for the Growth of Large Size Sapphire with Sapmac Method;SAPMAC法大尺寸蓝宝石晶体生长的模拟分析与应用研究

16.Application of B-spline Function Bases in the Investigation of Quantum Size Effects of the Semiconductor Crystallites Quantum Dots;B样条函数基在半导体微晶量子尺寸效应研究中的应用

17.Effect of Reversing Cold Rolling on Texture and Ferrite Grain Size of Steel Sheet可逆式冷轧对钢板织构及铁素体晶粒尺寸的影响

18.Study on the Growth and Properties of Large Infrared Nonlinear Optical Crystal LiInS_2大尺寸红外非线性光学晶体LiInS_2的生长与性能研究

相关短句/例句

size of crystal晶体尺寸

1.So thesize of crystals is very important to the energy resolution.因此对晶体的尺寸提出了较高的要求,要求晶体尺寸长度误差(-1~+1)mm,宽度误差为(0~-200)μm。

3)austenite grain size奥氏体晶粒尺寸

1.?The dynamic recrystallization andaustenite grain size after recrystallization in a new MnCr gear steel were studied at a strain up to 07, at a range of temperature from 850 to 1?150?℃, at strain rate from 01 to 1 s-1 and at initialaustenite grain size from 70 to 150?μm using a Gleeble 1500 thermomechanical test system.1~1s-1,变形温度为850~1150℃,原始奥氏体晶粒尺寸为70~150μm条件下的动态再结晶行为及再结晶后奥氏体晶粒尺寸的变化规律·研究结果表明:在一定的变形量下,变形速率、变形温度、奥氏体晶粒尺寸是影响再结晶的3个因素,只有变形条件Z小于上临界值Zc时才会发生动态再结晶·再结晶后奥氏体晶粒尺寸 D是由变形条件Z惟一地决定而与原始奥氏体晶粒大小无关,Z增加, D减小,二者符合关系式Z=A D-3。

2.At the same time, effects of rolling temperature and deformed amount onaustenite grain size in AH36 steel were also studied with duo mill.在轧制温度一定时 ,变形量和钛含量增加 ,奥氏体晶粒尺寸减小。

4)ferrite grain size铁素体晶粒尺寸

1.Double experiments of controlled rolling/cooling process were carried out on a lab mill and the results showed that the effect offerrite grain size on the mechanical properties is greater than that of pearlite morphology for the low-carbon cold heading steel.对低碳铆螺钢采用两次控轧控冷试验,结果表明,铁素体晶粒尺寸比珠光体形态对低碳铆螺钢力学性能的影响要大。

2.A study on effect of reversing cold rolling on texture andferrite grain size of DX51D(LCAK steel) and DX54D(IF steel) has been done by simulating experiment of reversing and continuous cold rolling and annealing in the laboratory.在实验室通过可逆式和连续式冷轧及退火模拟试验,研究了可逆式冷轧对DX51D(低碳铝镇静钢)和DX54D(无间隙原子钢)钢板织构及铁素体晶粒尺寸的影响。

5)grain size晶粒尺寸

1.Influence of wire rolling process parameters on austenitegrain size of high carbon steel;高碳钢线材轧制工艺参数对晶粒尺寸的影响

2.Prediction of the flow behavior andgrain size during forming for nickel alloy heavy forging;镍基合金大锻件成形过程流变行为与晶粒尺寸预测

3.Modelling forgrain size and flow stress of magnesium alloy based on BP neural network;基于BP神经网络的镁合金晶粒尺寸及流变应力模型

6)crystallite size微晶尺寸

1.The increase ofcrystallite size and notable changes of orientation factor for crystal planes during blow molding process reveale.结果表明经过吹塑成型过程后,TPCC的熔融温度、结晶度均较TPC有所提高,DSC熔融半峰宽明显下降,微晶尺寸明显增大,同时晶面取向因子发生显著变化,表明成型过程中晶区尺寸增大,且晶体结构更均匀规整,赋予了输液瓶良好的性能。

2.Thecrystallite size, degree of crystallinity( X c) and thermal properties of the [poly(cyanoarylether PCE)] at various temperatures have been studied by using WAXD and DSC.利用广角 X射线衍射 (WAXD)方法和示差扫描量热法 (DSC)研究了不同热处理温度时聚芳醚腈 (PCE)的微晶尺寸、结晶度及热性能的变化。

3.The resultsshowed that after the treatment of cellulose with L-NH3, the lateral order distribution,crystallinity,crystallite size and lattice form of cellulose were dramatically changed.结果表明,液氮处理后纤维素的侧序分布、结晶度、微晶尺寸、晶格形态都发生深刻的变化。

延伸阅读

工程图标准尺寸及坐标尺寸标准标注类型,是我们常用的标注类型。而坐标标注是便于数控加工采用的另一中标注形式。PRO/E可以将两种标注方式进行转换。· 3.2 标准标注到坐标标注的转换注意: 转化为坐标标注的尺寸必须是线性标注的,下列尺寸不能转化为坐标标注:被显示成线性尺寸的直径 中心线尺寸

    选择MODIFY DRAW > Dim Params > Dim Type > Ordinate Dim > Create Base. 选择作为参考基准线的尺寸 选择基准的引出线,该点为0点 选择 MOD DIM TYPE > Lin to Ord . 选择线性尺寸:注意:必须选择具有相同基准的尺寸
========>>>>· 3.3 由坐标标注到标准标注的转化 1. 选择 DIM PARAMS > Diam Dim Type .2.点击Ord to Lin 3.选择尺寸即可

本内容不代表本网观点和政治立场,如有侵犯你的权益请联系我们处理。
网友评论
网友评论仅供其表达个人看法,并不表明网站立场。