变换器/推挽正激,converter/push-pull forward
1)converter/push-pull forward变换器/推挽正激
2)push-pull forward converter推挽正激变换器
1.It comprises of apush-pull forward converter and a dual buck inverter.主电路采用推挽正激变换器和双降压式逆变器。
2.In this paper a novelpush-pull forward converter is introduced and analyzed in detail, then the design procedure of the power stage, drive circuit and high frequency transformer is introduced.介绍了一种倍流整流推挽正激DC-DC变换器,分析了其工作原理,论述了该变换器主电路、驱动电路及脉冲变压器的设计,最后通过样机实验,验证了推挽正激变换器的优点。
英文短句/例句
1.Development of 600W 28VDC/360VDC Push-pull Forward Converter and Research on Bias-magnetic;600W 28VDC/360VDC推挽正激变换器的研制及偏磁研究
2.The Research and Realization of ZCT Push-Pull Forward DC/DC Converter;推挽正激零电流转换DC/DC变换器的研究与实现
3.Push-pull Forward Three-level DC/DC Converter and Its Control Strategy推挽正激三电平直流变换器及其控制策略
4.Design of Power Converter in Vehicle Based on the Topology of Push Pull Forward;基于推挽正激拓扑的车载电源转换器
5.Research on the Push-pull Full-bridge Bi-directional DC-DC Converter;推挽全桥双向DC-DC变换器的研究
6.The Analysis of a Push-Pull Converter Failure Based on ST3525基于ST3525的推挽变换器故障的分析
7.A Novel Push-pull ZVS Boost Converter With Active Clamping一种新型有源箝位推挽ZVS Boost变换器
8.A Research on Push-pull Converter with Coupled Inductor采用耦合电感均流的推挽式直流变换器的研究
9.A New LCL Resonant Soft-Switching Push-Pull DC-DC Converter一种新型LCL谐振软开关推挽式直流变换器
10.Analysis of Push-Pull Convertor Used in Ultrasonic Motor Drive驱动超声波电机的推挽式变换器工作过程分析
11.Study of Double Forward Three-Level Converter;双正激三电平DC/DC变换器研究
12.Active Clamp Forward Converter Based on One-Cycle Control;单周控制有源箝位正激变换器的研究
13.Research on Active Clamp ZVS-PWM Forward Converter;有源钳位ZVS-PWM正激变换器的研究
14.Research on Digital Controlled Forward Converter with Active-Clamp Reset;数字控制有源箝位正激变换器的研究
15.Forward-Mode Three-Level AC/AC Converter正激式交-交型三电平AC/AC变换器
16.Novel Interleaving Double Switch Forward Soft Switching Converter新型交错并联双管正激软开关变换器
17.Small Signal Model of Active Clamp Forward Converter有源箝位正激变换器交流小信号模型
18.Design of Multiple Output DC/DC Forward Converter正激式DC/DC多路输出变换器设计
相关短句/例句
push-pull forward converter推挽正激变换器
1.It comprises of apush-pull forward converter and a dual buck inverter.主电路采用推挽正激变换器和双降压式逆变器。
2.In this paper a novelpush-pull forward converter is introduced and analyzed in detail, then the design procedure of the power stage, drive circuit and high frequency transformer is introduced.介绍了一种倍流整流推挽正激DC-DC变换器,分析了其工作原理,论述了该变换器主电路、驱动电路及脉冲变压器的设计,最后通过样机实验,验证了推挽正激变换器的优点。
3)Push-pull forward converter正激推挽变换器
4)converter/PPFC变换器/推挽正激变换器
5)transformer/push-pull forward变压器/推挽正激
6)push-pull converter推挽变换器
1.In this paper,voltage loop and peak-value current loop are used to control a high power DC/DC converter,one strategy to eliminate the transformer magnetic bias is proposed,3 kWpush-pull converter is designed and MATLAB verifys the strategy of eliminating the transformer magnetic bias.利用了电压环和峰值电流环控制大功率推挽DC/DC变换器,提出消除主变偏磁的策略,设计了3kW推挽变换器,利用MATLAB仿真验证了该控制策略可以消除主变偏磁。
2.The Boost converter with transformer-isolated was used in Boost mode,which was cascaded by a Boost converter and apush-pull converter,eliminating the redundancy com-ponents by a control strategy,a novel step-up circuit topology was formed.提出了一种新颖的双向DC/DC变换器,降压时采用移相控制ZVZCS-PWM全桥功率变换,控制简单,效率较高,升压时采用带变压器隔离的Boost变换器,利用Boost变换器与推挽变换器的级联,通过一种控制策略,去掉冗余元件,得到一种新颖的升压电路拓扑。
3.There are some intrinsic drawbacks in traditionalpush-pull converter,such as higher voltagestress and hard-switching of the switches,so the application area of the converter is limited.传统的推挽变换器存在着一些固有的缺点,诸如开关管的电压应力高、难以实现软开关等,限制了它的应用范围。
延伸阅读
变换变换transformation变换[t闭sfom.d佣;n碑。印臼o.a““e]集合M(一般被赋予某种结构)到其自身的一个映射u.元素“任M在变换u下的象，记为“(幻，u:.“。或:“.集合M到其自身的所有变换的集合关于乘法(合成)构成一个变换半群，称为M上的对称变换半群(t ransforrr口tlon~·grouP)).这个半群的可逆元称为置换(见集合的置换(详皿讯ationofa set)).集合M上的所有置换构成对称半群的一个子群—对称群(s)1~tilcgro叩).亦见置换群(pernlutation grouP);变换群(tral招-forll飞吐ion脚uP).0.A.比aH阳a撰杜小杨译
